Adjustable Alignment Cams for D44 / D50 maintenance parts

Adjustable Alignment Cams for D44 / D50 maintenance partsWhen a vehicle is lifted, the camber and caster are affected. Alignment eccentric cams are installed to help correct camber and caster. These are to only be used on Dana 44 Twin Traction Beams. (80 96 Bronco 80 96 4WD F150) Features: Adjustable design Corrects caster and camber up to 2. 5* for modified suspension.

Extended Length (in): 34

however it has a massive strength advantage due to its much larger diameter components

All U-Bolts are square top for fit on stock Ford stamped U bolt retaining plates

These motor mounts require you to "massage" the firewall in order to allow the engine to sit far enough back to utilize the factory

The beams have 3/16 steel plating formed and welded to all vulnerable areas of the housings

This bracket is no longer available from Ford

Retain Factory location

92-04 Ford Dana 60 Ball Joint Axle

or a complete front and rear package

Included is a vented

Provides 11” of travel

It will raise the front end of your Bronco / F150 approximately 2" giving you better ride and clearance for larger tires while increasing your suspension travel